Skip to content
Stern Didactic GmbH
  1. 01 / 05

    OPENED UP.ALL INSIDE.

    Base, roof, four Mecanum wheels, four DC motors, the board and the 9 V battery. Housing and wheels come from the 3D printer, printed in PLA.

    Printed part · Plastic · Guide time 1.5 h

    What this part involves

    1. Base sketch with centre-point rectangle and switch cut-out
    2. Cut the recess for the circuit board
    3. Sketch the motor profile, one side only
    4. Cut the motor profile and add the 7 mm chamfer
    Exploded view of the rover: roof on top, below it the board with Arduino and 9 V battery, base, motors and wheels outside.
  2. 03 / 05

    FOUR MOTORS.FOUR WHEELS.

    Every wheel has its own DC motor. Only this way can each wheel be controlled on its own, and the rover can turn on the spot.

    The rover from above with the four DC motors at the wheels.
  3. 05 / 05

    FIVE DAYS.ONE VEHICLE.

    In the Design & Make workshop the rover is built in five days: design, print, solder, program. The bundle with all parts costs 99.98 euros.

    Assembly · Guide time 1.5 h

    What this part involves

    1. Insert the base plate and ground it as the reference part
    2. Fit four DC motors with rigid joints
    3. Insert the PCB and combine it into a rigid group
    4. Fit the roof

    To the workshopKits in the shop

    The finished Mecanum rover from the side.

Model: Autodesk Fusion, Stern Didactic. Taken over without simplification; what is hidden in Fusion is missing here too.