Calculator
CALCULATE LIKEIN THE WORKSHOP.
Eleven calculators for metalworking, electrical and mechatronics training. Each shows the formula, works through an example from one of our training projects and lists common mistakes from exams and the workshop.
Machining
Spindle speed and cutting speed
Calculate spindle speed from cutting speed and diameter, or the other way round: for turning, milling and drilling.
Feed rate for milling
Calculate the feed rate from feed per tooth, number of teeth and spindle speed.
Machining time for longitudinal turning
Calculate the machining time from feed travel, number of cuts, feed and spindle speed.
Sheet metal, parts, threads
Bend calculation: flat length
Calculate the blank length of an angle or U-profile from flange dimensions, sheet thickness, bend radius and K-factor, as an approximation.
Bolt circle: hole coordinates
x and y coordinates of equally spaced holes from bolt circle diameter, number and start angle, plus hole spacing and crank turns on the dividing head.
Mass from volume and density
Calculate the mass of a block, cylinder or tube with selectable density: for blanks, handling or cross-checking the drawing.
Tap drill diameter for internal threads
Drill diameter for metric internal threads with the rule of thumb d − P, plus the minor diameter of the internal thread for comparison.
Mechanics
Electrical engineering
Ohm’s law and electrical power
Enter two of U, I, R and P; the other two are calculated. Plus series and parallel connection of two resistors.
Series resistor for LEDs
Calculate the series resistor from supply voltage, forward voltage and current, with power dissipation and the next standard value from E12 or E24.
The calculator works with formulas only. You enter values from standards, handbooks and data sheets yourself. Check results before manufacturing.