Calculator · Sheet metal, parts, threads
MASSFROM VOLUME AND DENSITY.
Mass is volume times density. For the blank a basic shape is usually enough: flat bar as a block, round bar as a cylinder, tube as a hollow cylinder. Comparing with the mass from the CAD model shows how much material is machined away.
The calculator works with formulas only. You enter values from standards, handbooks and data sheets yourself. Check results before manufacturing.
Formula
Mass equals volume times density.
Cuboid
Flat bar, plates, sheet blanks.
Cylinder
Round bar, pins, shafts.
Tube
Hollow cylinder; d is the inside diameter, i.e. D minus twice the wall thickness.
Lengths in mm give mm³. Divided by 1000 this gives cm³, matching density in g/cm³.
Quantities and units
| Mass | g | |
| Volume | cm³ | |
| Density | g/cm³ | |
| , , , , | Dimensions of the basic shape | mm |
Worked example
Buggy chassis: steel blank 130 × 70 × 10 mm
Given: , , ,
The drawing states 693.457 g. The difference of 20.9 g is the material removed by milling.
Densities as example values
| Material | g/cm³ | Note |
|---|---|---|
| Steel, unalloyed | 7.85 | Literature: 7.85 to 7.87 g/cm³ |
| Aluminium, pure | 2.70 | 2.6989 g/cm³ at 20 °C; alloys differ |
| Copper | 8.96 | at 20 °C |
| Brass | 8.4 to 8.9 | depending on zinc content, e.g. 8.41 g/cm³ for CuZn40 |
| PLA (3D printing) | 1.24 | data sheets of common filaments; printed parts with infill are lighter |
Guide value, follow the manufacturer’s data.
Common mistakes
- mm³ multiplied directly by g/cm³: the result is 1000 times too large.
- Wall thickness used instead of inside diameter for a tube: d = D − 2 · wall thickness.
- Density of pure aluminium used for an alloy: for exact values use the material data sheet.
- Solid material assumed for a 3D print: infill and wall count reduce the actual mass; the calculation gives the upper limit.
In the training project
The buggy’s chassis and engine block dossiers contain exactly this cross-check: blank mass against drawing mass.
On the wind turbine tower apprentices confirm the material aluminium with a volume and density calculation on the truncated cone.
Frequently asked questions
Why does my result not match the mass in CAD?
The blank still contains the material that will be machined away. The result also depends on the density: check which material is assigned in the CAD model.
What is the density of steel?
Unalloyed steel is about 7.85 g/cm³. That is a guide value; alloy steels differ slightly.
More calculators
Sources
- Wikipedia (German): steel, aluminium, copper, brass (density values)
- Technical data sheet Bambu Lab PLA Basic (density to ISO 1183)
- Stern Didactic: part dossier chassis, buggy project