Calculator · Machining
SPINDLE SPEEDFROM CUTTING SPEED.
You choose the cutting speed according to workpiece and cutting material; on the machine you set the spindle speed . The diameter links the two: the workpiece diameter for turning, the tool diameter for milling and drilling.
The calculator works with formulas only. You enter values from standards, handbooks and data sheets yourself. Check results before manufacturing.
Formula
The factor 1000 converts metres to millimetres, because is given in m/min and in mm.
Rearranged for
The other way round: which cutting speed results from a set spindle speed?
Quantities and units
| Spindle speed | 1/min | |
| Cutting speed | m/min | |
| Diameter: workpiece for turning, tool for milling and drilling | mm |
Worked example
Pivot pin on the race car, ⌀ 5 mm, finishing at (guide value from the part dossier, follow the manufacturer’s data)
Given: ,
If the machine is limited to , working backwards gives
.Small diameters need high speeds. If exceeds the maximum speed, drops; the feed then has to match the new speed.
Common mistakes
- Radius used instead of diameter: the speed comes out twice as high.
- Tool diameter used for turning: in turning the workpiece diameter at the cutting edge counts.
- Factor 1000 forgotten: the result is off by a factor of 1000.
- Facing calculated with a fixed speed: towards the centre drops to zero. CNC lathes keep constant with G96 and limit the maximum speed.
- Cutting speed taken without regard to the cutting material: values for carbide and HSS differ widely.
In the training project
On the race car the suspension pivot pin is turned to ⌀ 5 mm. There the machine’s speed limit decides the cutting speed.
View project: Mechanical race car – rolling bearings and ISO GPS
On the buggy apprentices compare the steel chassis and the aluminium engine block: same formula, very different cutting speeds.
In the Design & Race workshop participants set the cutting data in the CAM environment of Autodesk Fusion and mill their parts.
In Nullpunkt apprentices choose settings and tools on virtual machines before they machine.
Frequently asked questions
Which diameter do I use for drilling?
The nominal diameter of the drill. For milling it is the cutter diameter, for turning the workpiece diameter at the cutting edge.
Where does the value for come from?
From the tool manufacturer’s data or a reference handbook, depending on material, cutting material and operation. The calculator only converts; it does not suggest a guide value.
More calculators
Sources
- Stern Didactic: part dossier suspension axle, race car (mechanical) project