Calculator · Machining
FEED RATEFOR MILLING.
The tool manufacturer specifies the feed per tooth : the feed per cutting edge, i.e. the distance the tool advances before the next edge engages. The CNC program or the machine needs the feed rate in mm/min.
The calculator works with formulas only. You enter values from standards, handbooks and data sheets yourself. Check results before manufacturing.
Formula
Each cutting edge removes a chip of roughly thickness on every revolution; per revolution the tool advances by .
Feed per revolution of the tool.
Quantities and units
| Feed rate | mm/min | |
| Feed per tooth | mm | |
| Number of cutting edges | – | |
| Spindle speed | 1/min |
Worked example
Aluminium engine block on the buggy: carbide end mill ⌀ 8 mm, 3 flutes, . The dossier gives (); if the machine cannot reach that, (guide values, follow the manufacturer’s data)
Given: , , ,
Speed at :
, set to on the machine.
Common mistakes
- Feed per revolution confused with feed per tooth : the result is off by a factor of .
- Feed per tooth too small: the edge rubs instead of cutting. On aluminium a built-up edge forms and the surface smears.
- Speed changed, feed not: lowering while keeping increases the feed per tooth.
- Units mixed up: is in mm/min, and in mm.
In the training project
On the aluminium engine block in the buggy project apprentices calculate cutting speed, spindle speed and feed and explain why the values are higher than for steel.
In the Design & Race workshop milling operations are programmed in Autodesk Fusion: facing, contours, pockets, holes.
Frequently asked questions
Why does the manufacturer give rather than ?
describes the load on each cutting edge and applies regardless of speed and number of teeth. only follows from the specific combination of tool and speed.
Does the formula also apply to drilling?
For drilling you usually work with feed per revolution: . It is the same formula, because .
More calculators
Sources
- Stern Didactic: part dossier engine block, buggy project