Calculator · Machining
CUTTING TIMEFOR LONGITUDINAL TURNING.
The machining time is the time during which the tool moves at feed. It is the basis for production time and for comparing cutting data. Set-up, auxiliary and allowance times are added in costing.
The calculator works with formulas only. You enter values from standards, handbooks and data sheets yourself. Check results before manufacturing.
Formula
is the feed rate in mm/min. Distance divided by speed gives the time, multiplied by the number of cuts.
The feed travel covers the turning length plus the distance the tool travels at feed before and after the cut.
Quantities and units
| Machining time | min | |
| Feed travel | mm | |
| , , | Turning length, approach, overrun | mm |
| Number of cuts | – | |
| Feed per revolution | mm | |
| Spindle speed | 1/min |
Worked example
Wind turbine tower: aluminium blank ⌀ 50 mm, 220 mm turning length, roughing in two cuts with and with carbide (guide values from the dossier, follow the manufacturer’s data)
Given: ,
Speed:
, set to .
Common mistakes
- Approach and overrun forgotten: on short workpieces they make up a large share.
- Feed rate in mm/min used instead of feed per revolution: the formula needs in mm.
- Speed not recalculated for finishing: after roughing the diameter is smaller, so rises at the same cutting speed.
- Calculated with a fixed speed although the machine runs at constant cutting speed: then changes along the length, for example on a taper, and the formula only applies section by section.
In the training project
The wind turbine tower is an aluminium truncated cone, 220 mm long, ⌀ 50 mm at the bottom and ⌀ 30 mm at the top: the machining centrepiece of the project.
In Nullpunkt apprentices machine the parts virtually on real machines from the original drawing.
Frequently asked questions
Does the tool’s return travel count as machining time?
No. Rapid traverse and return travel belong to auxiliary time. Machining time only covers movement at feed.
How do I calculate facing?
For solid stock the turning length is half the diameter plus the approach. With a fixed speed the same formula applies. With constant cutting speed the speed rises towards the centre up to the limit; the formula is then only an approximation.
More calculators
Sources
- Stern Didactic: part dossier turbine tower, wind turbine project