Calculator · Sheet metal, parts, threads
BOLT CIRCLEIN COORDINATES.
For CNC programming or marking out you need the hole centres as coordinates. The calculator spaces the holes evenly on the bolt circle and outputs a table. The angle is measured from the positive x axis, counter-clockwise.
The calculator works with formulas only. You enter values from standards, handbooks and data sheets yourself. Check results before manufacturing.
Formula
Angle of the -th hole.
Coordinates of the hole centre
and are the centre of the bolt circle.
Hole spacing: chord between two neighbouring holes, handy for checking with a caliper.
Dividing head
On a dividing head with a 40 : 1 worm ratio. The fraction is set with an index plate whose hole count is divisible by the denominator.
Quantities and units
| Bolt circle diameter | mm | |
| Number of holes | – | |
| Angle of the first hole | ° | |
| , | Centre of the bolt circle in the workpiece coordinate system | mm |
Worked example
Flange with six holes on a ⌀ 60 mm bolt circle, first hole at 0°
Given: , ,
Hole 1: , . Hole 2:
, .Dividing head: gives crank turns per division. For three divisions at 120° it is , i.e. .
Common mistakes
- Radius and diameter confused: all coordinates are twice or half as large.
- Calculator set to radians: sin and cos then give wrong values for angles in degrees.
- Angle counted clockwise: the order of the holes then does not match the drawing.
- Centre forgotten: if the bolt circle is not at the workpiece origin, x0 and y0 belong in every coordinate.
In the training project
The wind turbine hub carries three M4 threads at 120°. Apprentices divide the circumference with the dividing head and calculate crank turns, index circle and hole count.
The inner wheel half of the Mecanum rover carries six roller mounts, arranged as a circular pattern in Autodesk Fusion.
Frequently asked questions
How do I check a bolt circle without a coordinate measuring machine?
Using the hole spacing: measure the distance between neighbouring holes, for example over two gauge pins, and compare it with l = D · sin(180° / n).
Why do values like 25.981 mm come up?
The sine and cosine of most pitch angles are not round numbers. Round only at the end, to the precision required by drawing and control.
More calculators
Sources
- Stern Didactic: part dossier hub, wind turbine project