Calculator · Sheet metal, parts, threads
TAP DRILLFOR METRIC THREADS.
For metric ISO threads the rule of thumb is: tap drill equals nominal diameter minus pitch. It is an approximation for thread cutting. Take the pitch from the thread designation, the drawing or your reference handbook; this calculator does not supply table values.
The calculator works with formulas only. You enter values from standards, handbooks and data sheets yourself. Check results before manufacturing.
Formula
Rule of thumb for metric ISO threads, coarse and fine.
Minor diameter
Minor diameter of the internal thread from the basic profile in ISO 68-1. The tap drill by rule of thumb is slightly larger: the thread is not formed quite to full depth, which makes tapping easier.
Quantities and units
| Tap drill diameter | mm | |
| Nominal thread diameter | mm | |
| Pitch | mm | |
| Minor diameter of the internal thread | mm |
Worked example
Three M4 threads on the wind turbine hub
Given: ,
For comparison:
. The drill is 0.058 mm larger.In the project the holes are drilled 10 mm deep and tapped 8 mm deep: the hole is deeper than the thread because the tap has a chamfer.
Common mistakes
- Fine thread calculated with the coarse pitch: for M10 × 1, , as the designation says.
- Rule of thumb used for thread forming: chipless forming needs larger pilot holes. Follow the manufacturer’s data.
- Hole too shallow: the drilling depth must exceed the usable thread depth, because the tap has a chamfer.
- Tapped without countersink: a small chamfer on the hole eases starting and prevents a raised edge.
In the training project
On the wind turbine hub three M4 threads with 8 mm thread depth are tapped into ⌀ 3.3 × 10 mm holes, evenly spaced at 120°.
Frequently asked questions
Why does my handbook sometimes give a different value?
Tables give drill diameters matched to standard drill sizes and tolerances. The rule of thumb gives an approximation; if they differ, the handbook or manufacturer’s catalogue applies.
Does the rule of thumb also apply to fine threads?
Yes, with the pitch of the fine thread, for example M10 × 1: 10 − 1 = 9 mm.
More calculators
Sources
- Stern Didactic: part dossier hub, wind turbine project