Calculator · Electrical engineering
OHM’S LAWAND POWER.
Voltage, current, resistance and power are linked by two equations: U = R · I and P = U · I. If two quantities are known, the other two follow. This applies to ohmic loads whose resistance does not change with voltage.
The calculator works with formulas only. You enter values from standards, handbooks and data sheets yourself. Check results before manufacturing.
Formula
Ohm’s law.
Electrical power; the three forms are equivalent.
Series
The current is the same everywhere, the voltages add up.
Parallel
The voltage is the same, the currents add up. The result is smaller than the smallest single resistor.
Quantities and units
| Voltage | V | |
| Current | A | |
| Resistance | Ω | |
| Power | W |
Worked example
Board powered from a 9 V battery, the multimeter shows 40 mA (assumed reading)
Given: ,
Two resistors and : in series , in parallel
.
Common mistakes
- Milliamps entered as amps: 40 mA is 0.04 A.
- Ohm’s law applied to LEDs or motors: their resistance is not constant; U / I only holds for the current operating point.
- Parallel resistance larger than the smallest single resistor: that is impossible, check the calculation.
- Power forgotten: a resistor with too low a power rating gets hot.
In the training project
On the Mecanum rover’s motor driver board apprentices measure the resistance between VIN and GND without battery or Arduino, with the switch off and on: there must be no continuity. They measure the current draw only at commissioning, with the Nano fitted.
In the Design & Make workshop the board is soldered, tested and commissioned.
Frequently asked questions
Why are there three formulas for power?
They are equivalent: substituting U = R · I into P = U · I gives P = I² · R or P = U² / R. You use the form whose quantities are known.
Does this also apply to AC?
For ohmic resistors yes, using RMS values. With inductors and capacitors phase shift and reactive power come in; this calculator does not cover that.
More calculators
Sources
- Stern Didactic: part dossier printed circuit board, Design & Make project