Calculator · Electrical engineering
SERIES RESISTORFOR LEDS.
An LED needs current limiting. In the simplest case that is a resistor in series: it drops the voltage the LED does not need. Forward voltage and current are given in the LED’s data sheet.
The calculator works with formulas only. You enter values from standards, handbooks and data sheets yourself. Check results before manufacturing.
Formula
The voltage across the resistor divided by the desired current; is the number of LEDs in series.
Power dissipated in the resistor. Choose a package with a sufficient rating.
Standard value
Choose the next higher value of the E series. The E12 and E24 series are defined in IEC 60063. The higher standard value keeps the current below the target.
Quantities and units
| Supply voltage | V | |
| LED forward voltage | V | |
| LED current | A | |
| Number of LEDs in series | – |
Worked example
Red indicator LED on 9 V (guide values, follow the LED data sheet)
Given: , ,
Next higher E12 value: . The current is then .
Power:
, a standard package is sufficient. In E24 it would be with .
Common mistakes
- Current entered in mA without converting: the result is 1000 times too small.
- Lower standard value chosen: more current flows than planned.
- Several LEDs in parallel on one shared resistor: because forward voltages vary, the current divides unevenly. Each LED needs its own resistor.
- Forward voltage guessed: it depends on colour and type; blue and white LEDs are much higher than red ones. Check the data sheet.
In the training project
The Mecanum rover board is powered from a 9 V battery. The worked example shows how an additional indicator LED would be protected at that voltage.
In the Design & Make workshop participants solder electronics with the Arduino Nano 33 IoT and put them into operation.
Frequently asked questions
What does E12 mean?
A series of standard resistor values with 12 values per decade: 1.0, 1.2, 1.5, 1.8, 2.2, 2.7, 3.3, 3.9, 4.7, 5.6, 6.8, 8.2, each times a power of ten. E24 has 24 values and finer steps. The series are defined in IEC 60063.
Why not just use a 1 kΩ resistor?
At 9 V and 2 V forward voltage, 1 kΩ gives 7 mA, which may be enough. At 3.3 V with a white LED, on the other hand, hardly any voltage is left for the resistor and the current depends heavily on tolerances. Calculating is safer than a fixed value.