Training project
DESIGN ONLINE – METHODS IN AUTODESK FUSION
9 lessons on an assembly robot: top-down, bottom-up, edit in place, shaft, CAM, electronics, generative design, drawing
Request a quoteOpen 3D model in Autodesk Fusion
- Original Fusion model
- Learning tasks in the MLS learning system
What it is about
Short learning series on the design methods of Autodesk Fusion using an assembly robot and its shaft, plus CAM milling, electronics, generative design, topology optimisation and drawings.
Learning objectives
- Choose between top-down, bottom-up and edit in place with reasons.
- Design, refine and draw a shaft to standard.
- Place CAM, electronics, generative design and topology optimisation within Autodesk Fusion.
AI mentor
This project is available in the AI mentor as 11 missions, from getting started through the parts to the review. With a licence the AI mentor tailors the tasks to you.
Lessons
- 01
Top-down design
You design parts directly in the assembly context without separate files, referencing existing geometry.
- 02
Bottom-up design
You design a shaft as a single part in its own file and then insert it into the assembly.
- 03
Edit in place
You create the shaft with edit in place: create a component and link it externally, save the assembly, work out the externally referenced component in the assembly context and define joints. This combines top-down and bottom-up.
- 04
Shaft design
You refine a shaft: isolate it, add retaining ring grooves and other typical features.
- 05
CAM milling
You set up an engine part in the CAM workspace, create a manufacturing model and generate the machining up to the machine code.
- 06
Electronic design
You get to know the electronics area: schematic, PCB layout and 3D board.
- 07
Generative design
You simplify a model, define preserve geometry, obstacles, loads and goals and compare the generated designs.
- 08
Topology optimisation
You reduce the weight of the housing with topology optimisation: define structural constraints and loads, choose a symmetry plane, set areas to preserve and turn the result into a model.
- 09
Creating drawings
You create a standard-compliant technical drawing of the shaft of an assembly robot: place the base view and a section view, add dimensions and sketches, adapt the title block and set surface symbols.
Content version 1.0.0.
Whether a workshop, a class set or a completely new training project: we will find the right model.