Skip to content
Stern Didactic GmbH

Knowledge · Electrical and mechatronics

Mecanum wheel

A Mecanum wheel is a wheel with freely rotating rollers around its circumference whose axes are usually at 45° to the wheel axis. Four such wheels allow a vehicle to move forwards, sideways and diagonally and to turn on the spot without steering.

Explanation

The wheel was developed in the early 1970s by the Swedish engineer Bengt Ilon. Because the rollers are angled, a rotating wheel produces a force at an angle to the vehicle's longitudinal axis. The force component along the roller axis is not transmitted by the freely rotating roller. The vehicle's motion results from superimposing the four angled forces.

For this there are wheels in two mirror-image versions. They are mounted in diagonal pairs so that, seen from above, the rollers form an X or an O. A sign pattern is enough for control: if all four wheels turn forwards, the vehicle goes straight ahead. If the diagonal pairs turn in opposite directions, it moves sideways. If the wheels on one side turn against those on the other, it rotates about its vertical axis. Speed is set separately via the PWM value.

Mecanum drives are found on industrial trucks, transport platforms and in robotics, wherever manoeuvring in tight spaces is needed. They are sensitive to uneven floors and unequal wheel loads.

Formulas and worked example

Given: Rover with

In practice: Design & Make – Mecanum rover, Mecanum wheel assembly

The Design & Make rover has four Mecanum wheels, two Wheel 1 and two Wheel 2, mirror-image and paired diagonally. Each wheel is 45 mm in diameter, 30 mm wide and is 3D printed together with its rollers. The project data also show how a mechanical fault disguises itself as a software problem: if the motors are skewed, the rollers no longer roll cleanly at 45° and the rover drifts during pure sideways travel.

To the training project Design & Make – Mecanum rover

Common mistakes

  • Fitting four identical wheels. The lateral forces then do not cancel and sideways travel does not work.
  • Looking for driving deviations only in the software. Often the cause is skewed motors or sticking rollers.
  • Adopting the sign pattern without checking it on the vehicle. The convention depends on mounting and wiring.

Related offers

Project Design & Make – Mecanum roverWorkshop Design & Make

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.