Design & Make – Mecanum Rover
LF 1
Naming the functional groups of the motor driver board and reading the silkscreen, checking continuity of the common ground and testing VIN against GND for short circuits, measuring current draw with the multimeter in series with the battery and narrowing down faults: is it the wiring or the program?
Parts: Printed Circuit Board (motor driver board) (soldering, assembly), Control and Programming (Arduino Nano 33 IoT) (programming)
LF 7
Programming the Arduino Nano 33 IoT: a pin table with 12 mappings, a drive command table with 11 rows as sign patterns of the four wheels, plus a watchdog that stops all motors when no new command arrives within a time limit (recommended design value 500 ms). The control is a microcontroller, not a PLC.
Parts: Control and Programming (Arduino Nano 33 IoT) (programming)
LF 8
Two L293D, each with four half bridges of which two at a time form an H bridge, for four DC motors: direction via two direction pins, speed via PWM on the enable pin, freewheeling and active braking as distinguishable operating states, freewheeling diodes against induced voltage. The assembly fixes which motor sits at which corner. Motors and drivers are given; selecting and sizing the drive are not part of it.
Parts: Printed Circuit Board (motor driver board) (soldering, assembly), Control and Programming (Arduino Nano 33 IoT) (programming), Complete Assembly – Mecanum Rover (assembly)
LF 9
Integrating the microcontroller into a communication system: as a Wi-Fi access point with a web server and virtual joystick, or via the Arduino Cloud with cloud variables and a dashboard; a connection watchdog stops the rover when the connection drops.
Parts: Control and Programming (Arduino Nano 33 IoT) (programming)
LF 10
Short-circuit test of VIN against GND before connecting the 9 V battery, then first power-up with current measurement; after that checking the direction of each motor individually and testing the watchdog before the rover may go on the floor. A small-scale subsystem, not an industrial plant; handover and user instruction are not part of it.
Parts: Printed Circuit Board (motor driver board) (soldering, assembly), Control and Programming (Arduino Nano 33 IoT) (programming)