Design & Make – Mecanum Rover
LF 1
Continuity check of the twelve control lines against the schematic, short-circuit check before first power-up, measuring current draw: testing functions by measurement and narrowing down faults, visual inspection first, then measurement, then replacing parts.
Parts: Printed Circuit Board (motor driver board) (soldering, assembly), Control and Programming (Arduino Nano 33 IoT) (programming)
LF 6
Populating the motor driver board with two L293D in through-hole technology (THT) and hand soldering it: reading the silkscreen, fitting parts with the correct polarity, working with ESD protection; then visual inspection, continuity and short-circuit testing and first power-up. The circuit is given; it is not designed in the project.
Parts: Printed Circuit Board (motor driver board) (soldering, assembly)
LF 7
Programming the Arduino Nano 33 IoT to the pin assignment in the schematic: two direction pins and one PWM-capable enable pin per motor, operation via Arduino Cloud or an access point web server, a watchdog stops the drive when operator input stops.
Parts: Control and Programming (Arduino Nano 33 IoT) (programming), Printed Circuit Board (motor driver board) (soldering, assembly)
LF 8
Integrating electronics into the device: fitting the circuit board, 9 V battery and eight motor leads into the housing, planning the cable routing and checking it for collisions in CAD before building.
Parts: Complete Assembly – Mecanum Rover (assembly), Printed Circuit Board (motor driver board) (soldering, assembly)