Skip to content
Stern Didactic GmbH

Knowledge · Manufacturing

Bend radius and springback

The bend radius is the inner radius of a bend; below a material-dependent minimum bend radius the outer fibre cracks. Springback is the elastic opening of the bend angle after the tool is released.

Explanation

The smaller the radius relative to the sheet thickness, the more the outside is stretched. How much a material can take depends on its formability: mild steel sheet can be bent tighter than high-strength steel or age-hardened aluminium. The rolling direction matters too; with the bend line across the rolling direction, tighter radii are possible than along it. The minimum bend radius is given in material data sheets and standards, as a multiple of the sheet thickness.

During bending part of the deformation becomes plastic and part stays elastic. After release the elastic part springs back and the angle opens. Springback is greater the higher the strength and the larger the radius relative to the thickness. It is compensated by overbending, by coining in the die or by a test bend with the original sheet. Small angle errors have a big effect on long legs: the offset at the end of the leg is roughly length · tan(angle error).

Formulas and worked example

  • Offset at the end of the leg

Given: ,

In practice: Truck, Loading platform

The truck's loading platform is bent from 1 mm steel sheet with an R2.5 radius, i.e. 2.5 times the sheet thickness. The project data call this uncritical and explain why rolling direction still matters. On the buggy's rear body they calculate the effect of springback: a 1° angle error on a 50 mm leg moves its end by about 0.87 mm. The wire-bent parts (windscreen) add the springback of round wire.

To the training project Truck

Common mistakes

  • Choosing a smaller tool radius than on the drawing. Cracks form on the outside and cannot be repaired.
  • Bending the workpiece directly without a test bend. The springback of that particular sheet is unknown.
  • Bending back a part that was bent too far. The material work-hardens in the bend zone and can crack.

Related offers

Project TruckProject BuggyNullpunkt: workshop in the browser

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.