Skip to content
Stern Didactic GmbH

Knowledge · Inspection and measurement

Inspection plan and characteristic

An inspection characteristic is a property of a workpiece that is checked, such as a diameter, an angle or a roughness. The inspection plan specifies for each characteristic the nominal value, tolerance, instrument, timing, sample size and documentation.

Explanation

The inspection plan is written before manufacturing, not afterwards. Writing it requires understanding the drawing: which dimensions matter for function, which merely follow from others? Where is the general tolerance enough, where is a more accurate instrument needed? Good plans also contain characteristics that do not appear as a dimension on the drawing but are decisive for function, such as the run-out of a bore relative to the outside diameter.

The inspection report records the results: actual value, assessment inside or outside tolerance, inspector and date. A dimensionless inspection drawing with numbered characteristics makes the assignment unambiguous. In training, apprentices learn this way to check their own work before someone else accepts it; this corresponds to the checking phase of the complete action.

In practice: Buggy, Rear body and wheel

The buggy's rear body comes with a dimensionless inspection drawing as the template for the inspection report. Because it is a bent part, the report has two parts: part A before bending with strip length, strip width, hole positions and bevels, part B on the bent part with the bend angles. For the wheel the apprentices write the inspection plan themselves: a plug gauge for ⌀6H7, an instrument for the spread across four wheels and the characteristic concentricity, which appears in no dimension.

To the training project Buggy

Common mistakes

  • Writing the plan only after manufacturing. Then the right instrument is often missing, or a feature is no longer accessible.
  • Checking only dimensioned sizes and forgetting functional characteristics such as run-out or squareness.
  • Not recording actual values, only ticking "OK". Without values, trends and tool wear cannot be spotted.

Related offers

Project BuggyNullpunkt: workshop in the browserWorkshop Design & Make

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.