Explanation
Reading takes two steps. First the whole millimetres: read the line on the main scale to the left of the vernier zero. Then the fractions: find the vernier line that lines up exactly with a line on the main scale. Its number times the resolution gives the decimal places. The resolution is 1 mm divided by the number of vernier divisions: 10 divisions give 0.1 mm, 20 give 0.05 mm, 50 give 0.02 mm.
A caliper measures outside dimensions with the jaws, inside dimensions with the inside jaws, depths with the depth rod and steps with the end face. Because the measuring point is not in line with the scale, it does not satisfy Abbe's principle: even slight tilting of the slide distorts the measurement. So measure as close to the beam as possible and use an even, light measuring force.
Digital calipers display the value directly. A display with 0.01 mm, however, does not mean the caliper measures that accurately. Choosing a measuring instrument depends on measurement uncertainty, not on the display.
Formulas and worked example
1/10 vernier: 0.1 mm, 1/20 vernier: 0.05 mm, 1/50 vernier: 0.02 mm.
Given: 1/20 vernier: zero line past 23 mm, the 9th vernier line aligns
In practice: Buggy, Chassis and engine block
For the buggy chassis the project data specify a 0 to 150 mm caliper with 0.02 mm reading, plus micrometers and a depth gauge for the counterbore depth. On the engine block they show the limit: with a 0.2 mm tolerance zone and a caliper repeatability of about 0.03 mm (guide value), roughly 15 percent of the zone is already used up, more than the one-tenth rule of thumb allows. A more accurate instrument is therefore recommended for the acceptance measurement.
Common mistakes
- Reading the millimetre value to the right of the zero line. The last full line to its left counts.
- Looking at the scale at an angle. The parallax error shifts the reading.
- Measuring with the tips of the jaws or tilting the slide. Abbe error and wear distort the value.
- Not checking zero before measuring.