Skip to content
Stern Didactic GmbH

Knowledge · Inspection and measurement

Inspection equipment

Inspection equipment covers all devices used to determine whether a workpiece meets the required characteristics. A distinction is made between measuring instruments that display a value, gauges that only establish good or reject, and auxiliaries such as stands or V-blocks.

Explanation

Measuring means comparing a quantity with a unit; the result is a number. Gauging means comparing a workpiece with an embodied limit; the result is good or reject. A plug gauge has a go side that must enter the bore and a no-go side that must not. Gauges are fast and unambiguous but give no value and therefore no information about trends.

Which instrument is suitable depends on the tolerance. A rule of thumb in metrology, often called the golden rule, requires the measurement uncertainty to be small compared with the tolerance, typically no more than a tenth of the tolerance zone. A caliper therefore suits general tolerances; fits need a micrometer, dial indicator, bore gauge or gauge.

Inspection equipment must be monitored: it is calibrated regularly, labelled and withdrawn when damaged. A workpiece is only as well inspected as the equipment it was inspected with.

In practice: Truck, Loading platform and truck tyre

On the truck's loading platform the project data apply the golden rule concretely: with a tolerance zone only 0.1 mm wide, a caliper with 0.05 mm reading is not acceptable. On the truck tyre a lever-type dial indicator is used for the run-out check. On the buggy wheel the ⌀6H7 fitted bore is checked with a 6 H7 plug gauge, go and no-go side.

To the training project Truck

Common mistakes

  • Choosing the instrument by its display rather than its measurement uncertainty.
  • Forcing a gauge into the bore. The go side must enter under its own weight or with light pressure.
  • Using instruments without valid calibration.

Related offers

Project TruckProject BuggyNullpunkt: workshop in the browser

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.