Skip to content
Stern Didactic GmbH

Knowledge · Drawings and tolerances

Fit

A fit describes how two parts with the same nominal size go together, typically a hole and a shaft. Depending on the position of the tolerance zones the result is a clearance fit, a transition fit or an interference fit.

Explanation

Under ISO 286 a tolerance is given by a letter and a number, e.g. ⌀20H8. The letter states the position of the tolerance zone relative to the nominal size (fundamental deviation), capitals for holes, lower case for shafts. The number is the tolerance grade: the smaller, the tighter. The numerical values are in the standard.

In a clearance fit the hole is always larger than the shaft; the parts can rotate or slide. In an interference fit the shaft is always larger; the parts are pressed or shrunk together. In a transition fit either clearance or interference can occur depending on the actual sizes; this is used for parts that must sit accurately yet still be assemblable.

So that not every combination needs its own tools and gauges, there are two systems. In the hole-basis system all holes have tolerance zone H (lower deviation zero) and the type of fit is chosen via the shaft. In the shaft-basis system all shafts have h and the choice is made via the hole. Hole basis is common in mechanical engineering because reamers and plug gauges for H holes are standard.

Formulas and worked example

  • Negative means interference.

Given: Wind turbine: hole ⌀20H8 (20.000 to 20.033 mm), shaft ⌀20e8 (19.927 to 19.960 mm)

  1. Clearance 0.040 to 0.106 mm: a clearance fit.

In practice: Wind turbine, Axle and rotor hub

The wind turbine axle has a ⌀20e8 fitted shank, the rotor hub a ⌀20H8 bore. The project data calculate the limits and a clearance of 0.040 to 0.106 mm: a pure clearance fit in the hole-basis system so the rotor can turn. On the race car the ball bearings sit in ⌀22J8 housings with the envelope requirement, i.e. a transition fit on the outer ring.

To the training project Wind turbine

Common mistakes

  • Mixing up capitals and lower case. H7 is a hole tolerance, h7 a shaft tolerance.
  • Checking a fitted bore with a caliper. Its measurement uncertainty is not good enough for IT7; use a plug gauge or internal measuring instrument.
  • Assembling a transition fit like a clearance fit. Without a press and suitable support both part and bearing suffer.

Related offers

Project Wind turbineProject Race car (mechanical)Workshop Design & Race

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.