Skip to content
Stern Didactic GmbH

Knowledge · Manufacturing

Undercut

An undercut is a small groove at the transition between two diameters of a shaft or at the end of a thread. It gives the tool or grinding wheel room to run out and makes sure a mating part can sit right against the shoulder.

Explanation

Without an undercut there is always a small radius at the shoulder of a shaft, because every cutting edge has a corner radius. A bearing or hub with a sharp edge would then sit on this radius instead of flat against the shoulder. Similarly with threads: a threading tool cannot cut right up to the collar, the last turns are incomplete. A nut would jam there before it seats.

For shaft shoulders that are ground and for thread run-outs there are standardised undercut forms that the drawing specifies only by a short designation. The dimensions themselves are in the relevant standard. An undercut reduces the cross-section; thanks to its radius, however, it acts less as a notch than a sharp groove.

On drawings a standardised undercut is usually shown in simplified form and designated by standard number and form, for example DIN 76-A at the end of a thread. On shafts that are ground after turning, the grinding wheel runs out into the undercut; the undercut surface itself stays unground. In turning, the undercut is cut in the same set-up as the adjacent diameters.

In practice: Wind turbine, Axle

The wind turbine axle has a ⌀20e8 fitted shank, an M12 threaded spigot and a DIN 76-A thread undercut at the transition. The project data cover the notch effect at the thread run-out. The race car's rear axle also has a DIN 76-A undercut on its M4 spigot, as does the self-made pivot pin of the suspension.

To the training project Wind turbine

Common mistakes

  • Leaving out the undercut because it seems unrelated to function. The nut or bearing then does not seat.
  • Plunging the undercut with a sharp corner instead of the specified radius. The notch effect increases.
  • Inventing undercut dimensions instead of referencing the standard. Manufacturing and inspection then have no clear specification.

Related offers

Project Wind turbineProject Race car (mechanical)Workshop Design & Race

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.