Explanation
Reading a drawing starts with the title block: name, drawing number, scale, material, general tolerance, projection symbol and revision. Only then come the views. The front view is the most informative view of the part; the other views are derived from it.
In first-angle projection the part is imagined in front of a projection plane and viewed from different sides. The top view sits below the front view, the view from the left to the right of it. In third-angle projection, common in North America, it is the other way round: top view above, view from the left on the left. The truncated-cone symbol in the title block shows which method applies.
Only as many views are drawn as needed for an unambiguous representation. Turned parts often need only one view because the diameter symbol ⌀ defines the round shape. Hidden edges are shown as narrow dashed lines; a section often replaces them better. The scale is in the title block; dimension values always state the true size, regardless of scale.
In practice: Buggy, Windscreen and drawing set
The buggy has a complete drawing set numbered 001 to 008. The full assembly is drawn at a scale of 1:2, the rear body at 1:1. The wire windscreen is the only part drawn at 2:1, because otherwise it would be too small for a readable drawing. Every sheet carries the general tolerance ISO 2768-m-K in the title block.
Common mistakes
- Measuring dimensions off the drawing instead of reading them. Scale and printing distort the result.
- Confusing first- and third-angle projection, e.g. on drawings from the USA. The part is then made mirror-inverted.
- Skipping the title block. Material, general tolerance and revision are only there.