Skip to content
Stern Didactic GmbH

Knowledge · Drawings and tolerances

Sectional view

A sectional view shows a part as if it had been cut along an imaginary plane. Internal features such as bores, pockets and wall thicknesses become visible and can be dimensioned; the cut surface is hatched.

Explanation

The cutting plane is marked in another view with a chain line and arrows showing the viewing direction. Capital letters name the section, for example A-A. Hatching consists of narrow lines, usually at 45°. Adjacent parts in an assembly get different hatching directions or spacings so they can be told apart.

There are various section types depending on the part. A full section cuts the whole part. A half section shows one half of a symmetrical part sectioned and the other as a view. Partial or broken-out sections reveal just one spot, such as a thread. A stepped section runs through several parallel planes to show several bores in one view.

Some elements are not shown sectioned lengthwise even though the cutting plane passes through them: shafts, screws, pins, ribs and spokes. Otherwise the drawing would suggest a solid body where there is none.

In practice: Design & Make – Mecanum rover, Roof (housing cover)

The Mecanum rover's housing cover is created in CAD from a solid with the shell command. How thick the walls are only becomes clear in section: the drawing shows 3 mm in section A-A and 5 mm in section B-B. On the buggy's engine block the step dimensions of 18, 15 and 10 mm of the pocket are given in section A-A, on the truck chassis thread depth and drilling depth in section B-B.

To the training project Design & Make – Mecanum rover

Common mistakes

  • Hatching screws and shafts lengthwise. They are shown unsectioned in the longitudinal direction.
  • Leaving out visible edges behind the cutting plane. They belong in the sectional view.
  • Misreading the arrows of the cutting plane. They show the viewing direction, not the side that is removed.

Related offers

Project Design & Make – Mecanum roverWorkshop Design & MakeProject Buggy

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.