Skip to content
Stern Didactic GmbH

Knowledge · Manufacturing

Tap drill hole

The tap drill hole is the hole into which an internal thread is cut or formed. For ISO metric coarse threads the rule of thumb is: tap drill diameter equals nominal diameter minus pitch.

Explanation

A tap cuts the thread profile out of the hole wall. If the tap drill hole is too small, it has to remove too much material, binds and breaks easily. If it is too large, the threads are not fully formed and the thread carries less load. The rule of thumb d − P gives a value at which the thread is formed deep enough and the tap cuts freely.

The formula does not apply to thread-forming tools (chipless): they displace material and need a larger hole. Here the manufacturer's data apply.

In blind holes the drilling depth is greater than the usable thread depth. The tap has a chamfer whose first threads do not cut a full profile, and the drill point needs room as well. Drawings therefore often carry two values, e.g. 10/15: 10 mm thread depth, 15 mm drilling depth.

Formulas and worked example

  • nominal diameter, pitch, both in mm.

  1. M5 with : .

  2. M3 with : .

  3. M12 with : , in practice 10.2 mm.

In practice: Truck, Truck chassis

The truck chassis has M5 threads in its end face, specified as 10/15 in section B-B: 10 mm usable thread depth, 15 mm drilling depth, tap drill 4.2 mm. The 5 mm difference is the run-out for the drill point and the tap chamfer. On the loading edge of the same project the calculation shows a limit: a ⌀2.5 mm tap drill hole for M3 in 5 mm thick material leaves only 1.25 mm of wall on each side.

To the training project Truck

Common mistakes

  • Pre-drilling at the nominal diameter, i.e. ⌀5 for M5. Then no load-bearing thread is formed.
  • Drilling blind holes only as deep as the thread. The tap bottoms out and breaks.
  • Using the coarse pitch for a fine thread. M10 × 1 needs a different tap drill than M10.
  • Using a thread former in a hole drilled for a cutting tap. The hole is too small and the tool is overloaded.

Related offers

Project TruckProject BuggyNullpunkt: workshop in the browser

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.