Explanation
In turning the workpiece rotates, in drilling and milling the tool does. In both cases a point on the cutting edge travels the circumference π · d per revolution. Multiplied by the spindle speed n this gives the cutting speed. Because d is given in millimetres and vc in metres per minute, the formula contains the factor 1000.
Cutting speed is not chosen freely but according to tool material (HSS, carbide), workpiece material, process and cooling. Tool manufacturers publish ranges for this. Values that are too high overheat the edge and wear it quickly; values that are too low cause built-up edges and poor surfaces in aluminium and soft steel. The spindle speed is only the result: it is calculated from vc and the diameter.
In facing, the effective diameter changes continuously. CNC lathes therefore keep the cutting speed constant with G96 and adjust the spindle speed continuously; a speed limit stops it from rising without bound towards the centre.
Formulas and worked example
Rearranged for
Given: Tap drill ⌀ 4.2 mm (HSS) in steel,
Guide value; follow the manufacturer’s data.
In practice: Buggy, Chassis
The buggy chassis is a milled steel part with M4, M5 and M6 threads. At the same cutting speed each tap drill needs a different spindle speed: the smaller the drill, the higher the speed. On the aluminium wind turbine tower, turning uses constant cutting speed (G96) so that the surface stays the same along the whole taper.
Common mistakes
- Copying a spindle speed from another job without checking the diameter: a drill half the size needs twice the speed.
- Mixing up millimetres and metres, i.e. forgetting the factor 1000. Result: speeds that are wrong by a factor of 1000.
- Running carbide values with an HSS tool. The edge loses its temper and is blunt after a short time.
- Not setting a speed limit with G96. When facing towards the centre the speed otherwise rises to the machine limit.