Explanation
Every cutting edge is a wedge. The face over which the chip flows is the rake face, the face towards the workpiece the flank. The angles are measured in a plane perpendicular to the cutting edge, relative to the cutting direction.
A large rake angle makes the edge sharper: cutting force drops and the chip flows easily. In return the wedge angle becomes smaller and the edge more fragile. For soft, ductile materials such as aluminium large rake angles are used, for hard materials smaller or even negative ones so the edge stays stable. The clearance angle is usually small, only a few degrees: just large enough that nothing rubs.
In turning the effective angles also depend on the height of the cutting edge. If it is above or below centre, clearance and rake angles change. That is why the turning tool is set to centre height.
Formulas and worked example
Clearance angle , wedge angle and rake angle add up to 90°.
Given: ,
In practice: Buggy, Engine block and wheel
The buggy's engine block and wheels are aluminium. The project data name the built-up edge as the typical fault: aluminium sticks to the edge and the surface is smeared instead of smooth. Remedies are sharp, polished tools with a large rake angle, large chip spaces and coolant. When reaming the ⌀6H7 wheel bore, the same mechanism occurs on the reamer's edges.
Common mistakes
- Using a tool meant for steel in aluminium. The small rake angle leads to built-up edges.
- Not setting the turning tool to centre height. Below centre the flank rubs, above centre the edge pushes.
- Forgetting the clearance angle when regrinding. Without clearance the edge rubs instead of cutting.