Skip to content
Stern Didactic GmbH

Knowledge · Manufacturing

Feed

Feed is the distance the tool or workpiece travels in the feed direction per revolution (f in mm) or per cutting edge (fz in mm). Feed rate vf in mm/min is the distance per minute the machine actually travels.

Explanation

In turning and drilling feed is given per revolution, f. In milling the load on each individual edge counts, so the calculation uses feed per tooth fz. The feed rate programmed as F in the NC program follows from fz, the number of teeth z and the spindle speed n.

Feed determines chip thickness, cutting force, surface finish and machining time. A larger feed shortens the time but increases the force and, in turning, the roughness, which grows roughly with the square of f. Too small a feed is harmful as well: the edge no longer cuts but rubs and squeezes. In aluminium this promotes built-up edges, in stainless steel work hardening of the surface.

Finishing uses smaller feeds than roughing. Tool manufacturers give starting values for fz depending on tool diameter and material.

Formulas and worked example

  • Milling

  • Turning and drilling

Given: Three-flute cutter, ,

Guide value; follow the manufacturer’s data.

In practice: Race car (mechanical), Front axle

The bearing journal of the race car's front axle requires Ra 0.8. The project data show how feed makes this possible: with a corner radius of 0.4 mm and f = 0.1 mm the theoretical roughness is about 3.1 µm, at f = 0.2 mm already 12.5 µm. Double the feed means four times the roughness. On the buggy's aluminium engine block the data warn of the opposite: if the feed is too small, aluminium smears onto the edge.

To the training project Race car (mechanical)

Common mistakes

  • Confusing feed per tooth with feed per revolution. With a four-flute cutter the difference is a factor of four.
  • Choosing a very small feed out of caution. The edge rubs, heats up and wears faster than at a normal feed.
  • Not adjusting the feed rate after changing the spindle speed. Then fz is no longer correct.

Related offers

Project Race car (mechanical)Project BuggyNullpunkt: workshop in the browser

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.