Skip to content
Stern Didactic GmbH

Knowledge · CAD and digital manufacturing

CAM

CAM (computer-aided manufacturing) is computer-aided planning of manufacturing: toolpaths are calculated from the 3D model, simulated and output as an NC program for a specific machine via a post processor.

Explanation

It starts with the setup: stock, fixturing and work coordinate system, i.e. the zero point to which all coordinates refer. Every fixturing needs its own setup. Then operations are created, each with a tool from the tool library, cutting data and strategy: facing, roughing, for example as adaptive clearing with constant tool engagement, finishing contours and pockets, drilling and threading.

The simulation shows material removal, collisions of tool, holder and fixture, and machining time. Only then does the post processor generate the NC program in the dialect of the specific control. A manufacturing model helps here: a copy of the design model in which manufacturing sizes or allowances may be adjusted without altering the drawing dimensions.

CAM does not replace expertise. Cutting data, clamping concept and sequence still need to be set by someone who understands what happens at the machine.

In practice: Buggy, Engine block and chassis

The buggy comes with a video series whose CAM parts show machining the engine block and chassis in Autodesk Fusion: manufacturing model, setup, work coordinate system, stock, tool library, the operations facing, drilling, adaptive clearing and 2D pocket, simulation and post processor. For the engine block the project data describe adaptive clearing with 0.5 mm stock to leave followed by finishing. The second side needs a second setup with its own zero point, which Fusion does not create automatically.

To the training project Buggy

Common mistakes

  • Skipping the simulation. Collisions with fixtures otherwise only show up at the machine.
  • Choosing the wrong post processor. The program then does not suit the control.
  • Placing the zero point differently in CAM than where it is probed on the machine. All dimensions are then offset.

Related offers

Project BuggyNullpunkt: workshop in the browserWorkshop Design & Race

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.