Explanation
The foundation is the sketch. Geometric constraints define what is parallel, perpendicular, tangent or coincident; dimensions define the sizes. Once a sketch is fully defined, no line can move unintentionally. Bodies are created from sketches by extrusion, revolution or sweep, followed by holes, chamfers, fillets and patterns. All steps are listed in the timeline (history) and can be edited afterwards.
Its real strength shows with variants. Instead of entering fixed numbers you create user parameters such as diameter, height or thread size and use them in formulas. A whole size range is then created by changing a few values. This requires a well-thought-out order: features should refer to stable references such as origin planes or main sketches, not to edges that disappear with the next change.
In training, working parametrically forces you to think about design intent: which dimension is leading, which follows from it? It is the same question as when dimensioning a drawing.
In practice: Design & Make – Mecanum rover, M10x10 and M12x10 screw fittings
In the Design & Make project the M12x10 screw fitting is created as a variant of the M10x10. The project data have apprentices assess the limits of "Save as" compared with true parametrics. As an extension they suggest replacing all dimensions of the fitting with user parameters, i.e. outer diameter, height, tooth width, tooth height, number of teeth and thread size, and creating a size range from M6 to M16. It must be recorded which parameters depend on each other.
To the training project Design & Make – Mecanum rover
Common mistakes
- Leaving sketches under-defined. Geometry shifts unnoticed with the next change.
- Building features on edges or faces from later steps. When something changes, the references break.
- Creating variants by copying instead of using parameters. Every correction must then be repeated in all copies.