Explanation
Chamfers have several tasks. On shafts and bores they make assembly easier: a pin finds its way into a chamfered bore by itself. At the start of a thread they protect the first turn from damage. On outer edges they remove the burr left by machining and prevent cuts. In assembly they also stop a sharp edge from sitting on a fillet of the mating part.
At 45° the drawing needs only width × 45°. Other angles are dimensioned by length and angle. Where no chamfer is drawn, a general edge condition in the title block can specify how edges are to be finished; there is a separate standard for workpiece edges.
In CAD the chamfer is usually modelled last. That keeps the model editable, and the chamfer follows if the edge changes.
In practice: Design & Make – Mecanum rover, Roof (housing cover)
The Mecanum rover's housing cover has 15 × 45° corner chamfers. The project data show that they are not only for looks: together with the draft angles and radii they make the cover printable by FDM without support, because a 45° surface can just about overhang freely. For the steel truck roof, "chamfer equals wall thickness" is explained as a term in its own right, and on the trailer coupling the deburring chamfer.
To the training project Design & Make – Mecanum rover
Common mistakes
- Modelling chamfers early in CAD and building later features on them. If the chamfer changes, dependencies break.
- Forgetting lead-in chamfers on fitted bores. The pin jams during assembly and damages the fitted surface.
- Choosing a chamfer so large that it reduces the bearing face of a screw or seal.