Skip to content
Stern Didactic GmbH

Knowledge · Manufacturing

Countersink and counterbore

A countersink or counterbore is an enlargement at the start of a hole that takes the screw head. Conical countersinks (usually 90°) are for countersunk screws, cylindrical counterbores for socket head cap screws.

Explanation

A countersink or counterbore lets the screw head sit flush or recessed. In a conical countersink the head bears on its conical face, which also centres the screw in the hole. A joint with several countersunk screws therefore tolerates little positional deviation of the holes: each head tries to centre itself. In a counterbore the head sits flat on the bottom and the clearance hole has play.

Countersink dimensions depend on the screw and are standardised; the drawing often needs only the countersink diameter and angle or depth. For a 90° countersink the depth is easy to calculate: it is half the difference between countersink diameter and hole diameter.

On thin sheet a countersink is critical: if the sheet is thinner than the head height, the countersink cuts through and the head bears only on an edge. An enlarged through hole such as ⌀8.6 on the buggy seat ensures the head still bears on the full cone.

Formulas and worked example

  • Countersink depth

  • At 90°

Given: Buggy seat: , , countersink angle 90°

  1. That is exactly the sheet thickness.

In practice: Buggy, Seat and chassis

The buggy seat is 2 mm steel sheet with a ⌀8.6 mm hole and a 90° countersink of ⌀12.6 mm. The project data show that the cone fills exactly the sheet thickness: (12.6 − 8.6) / 2 = 2.0 mm. The chassis of the same project instead has a ⌀10 mm counterbore 5.5 mm deep above a ⌀5.5 mm clearance hole, checked with a depth gauge.

To the training project Buggy

Common mistakes

  • Countersink too deep: the head sits below the surface, the bearing gets narrow and on thin sheet the cone cuts through.
  • Using a countersink tool with the wrong angle for countersunk screws. The head bears only on a line.
  • Using several countersunk screws on a part with an inaccurate hole pattern. The heads distort the part.

Related offers

Project BuggyProject Wind turbineNullpunkt: workshop in the browser

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.