Skip to content
Stern Didactic GmbH

Knowledge · Manufacturing

Flat pattern

The flat pattern is the flat blank of a bent part, i.e. the shape the sheet has before bending. Its length, the developed length, is calculated on the neutral fibre, whose length does not change during bending.

Explanation

During bending the sheet is stretched on the outside and compressed on the inside. Between them is a layer that keeps its length: the neutral fibre. With tight radii it does not lie at mid-thickness but closer to the inside. The K factor describes its position: K = 0.5 means mid-thickness, smaller values mean closer to the inner radius.

The developed length is the sum of the straight sections and the arc lengths on the neutral fibre. For each bend: arc = π · bend angle / 180° · (r + K · s). CAD programs calculate the flat pattern with a sheet metal rule that contains the K factor. Standard methods use a bend deduction. Both routes give slightly different lengths because they make different assumptions. A test bend shows which value is right on your own machine.

Everything that can be made in the flat state should be made there: holes, cut-outs, bevels. Holes close to the bend line, however, distort during bending.

Formulas and worked example

  • Per arc

Given: Rear body: U-profile, inside 70 mm and twice 50 mm, , , two 90° bends

In practice: Buggy, Rear body

The buggy's rear body is a U-shaped folded steel sheet, 1 mm thick, inner dimensions 70 mm base and two 50 mm legs, bend radius 1 mm. The drawing dimensions the flat pattern as 170.52 × 35 mm. The project data show where the number comes from: 166 mm of straight sections plus two arcs of about 2.262 mm each with K = 0.44 from the CAD sheet metal rule. Using the bend deduction from the standard gives 170.16 mm. The apprentices first measure the actual sheet thickness and calculate with that value.

To the training project Buggy

Common mistakes

  • Simply adding the outside dimensions. The part becomes too long because the arc is shorter than the corner.
  • Mixing inside and outside dimensions in the same calculation.
  • Calculating with the nominal thickness although the stock differs. On 1 mm sheet, tenths already make measurable length differences.
  • Placing holes close to the bend line and drilling them before bending. They distort into slots.

Related offers

Project BuggyProject TruckNullpunkt: workshop in the browser

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.