Skip to content
Stern Didactic GmbH

Knowledge · Inspection and measurement

Micrometer

The micrometer is an instrument for outside dimensions in which a measuring spindle with a fine thread converts length into rotation. With a 0.5 mm spindle pitch and 50 graduations on the thimble, 0.01 mm can be read.

Explanation

One turn of the thimble moves the spindle by the pitch, usually 0.5 mm. The sleeve shows whole and half millimetres, the thimble the hundredths. Reading: the last visible line on the sleeve, plus 0.5 mm if a half-millimetre line is visible, plus the thimble value at the reference line.

Unlike the caliper, the measuring path is in line with the spindle, so Abbe's principle is satisfied. A ratchet or friction clutch limits the measuring force so that every measurement uses the same pressure. Micrometers have a range of 25 mm, i.e. 0 to 25 mm, 25 to 50 mm and so on. From 25 mm upwards zero is checked with a setting standard.

Heat distorts the result: a steel frame expands in a warm hand. So hold the instrument by its insulating pads and do not measure workpieces straight after machining.

Formulas and worked example

Given: Sleeve 7 mm with half-millimetre line visible, thimble 23

In practice: Buggy, Rear body and wheel

Before calculating the rear body's flat pattern, the apprentices measure the actual sheet thickness with a micrometer at three points and calculate with that value, because thin sheet has a thickness tolerance. For the full assembly a 25 to 50 mm micrometer is specified to check the four wheel diameters. On the truck tyre the tread ⌀30 ±0.2 mm is measured with a micrometer.

To the training project Buggy

Common mistakes

  • Missing the half-millimetre line. The value is then 0.5 mm wrong.
  • Turning the thimble directly instead of using the ratchet. The measuring force varies and can upset the instrument.
  • Not checking zero with the setting standard on instruments from 25 mm upwards.

Related offers

Project BuggyProject TruckNullpunkt: workshop in the browser

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.