Explanation
The pitch P is the distance between two adjacent threads. The lead Ph is the axial distance a nut travels in one full turn. On single-start threads, i.e. almost all fastening threads, both are equal. On multi-start threads the lead is a multiple of the pitch.
Coarse threads are the normal case: robust, tolerant of dirt and available everywhere as standard parts. Fine threads have a smaller pitch. They allow finer adjustment, weaken thin-walled parts less and loosen less easily, but are more delicate. Threads are right-handed by default; left-hand threads are marked LH.
On drawings a thread is shown in simplified form: external threads with a wide line at the major diameter and a narrow line at the minor diameter, internal threads the other way round. The usable thread length is dimensioned, not the individual turns.
Formulas and worked example
is the lead: the travel per turn.
Given: M12 with , four turns
In practice: Design & Make – Mecanum rover, M12x10 screw fitting
The Mecanum rover from the Design & Make workshop has an M12x10 screw fitting made by 3D printing. The project data explain the M12 coarse thread with a 1.75 mm pitch and calculate the tap drill for a cut thread (12 − 1.75 = 10.25 mm, in practice 10.2 mm). In FDM printing, however, the thread is modelled as geometry. On the race car, the pivot pin carries an M4 × 5 mm thread with a thread undercut.
To the training project Design & Make – Mecanum rover
Common mistakes
- Treating pitch and lead as equal on multi-start threads.
- Leaving out the pitch on fine threads. M8 always means coarse thread.
- Showing the thread only cosmetically for 3D printing. A cosmetic thread is not contained in the mesh (STL); a smooth cylinder gets printed.