Skip to content
Stern Didactic GmbH

Knowledge · Manufacturing

Climb and conventional milling

In climb milling the cutter edge moves in the feed direction while engaged, and the chip goes from thick to thin. In conventional (up) milling it moves against the feed, and the chip starts thin and ends thick.

Explanation

Which type applies depends on the cutter's direction of rotation and the side on which it runs along the workpiece. With a right-hand cutter on an outer contour: if the material is on the right of the cutter (seen in the direction of travel), it is climb milling.

In conventional milling the edge starts at zero chip thickness. It first slides over the surface before it cuts. This creates friction, heat and a work-hardened surface layer. In climb milling it cuts in fully at once and exits thin, which is easier on edge and surface. In return the cutter pulls the workpiece in the feed direction. If the feed drive has backlash, as on many conventional milling machines, the table can jerk forward. Modern CNC machines with backlash-free ball screws therefore usually climb mill.

Conventional milling still has its place: on machines with backlash and on hard casting skin or scale, because the edge then enters from below the hard layer.

In practice: Race car (mechanical), Chassis and left and right wheel carriers

For the free-form surfaces on the race car's aluminium chassis the project data specify climb milling with a constant width of cut. The left and right wheel carriers are mirrored parts. Here the data ask how to mirror a CAD model and a CNC program without turning climb milling into conventional milling: simply mirroring a toolpath reverses the milling direction.

To the training project Race car (mechanical)

Common mistakes

  • Mirroring toolpaths without checking the milling direction. The mirrored program mills conventionally.
  • Climb milling on a conventional machine with screw backlash. The table can jump forward and the cutter breaks.
  • Using the same direction of travel on inner and outer contours. To stay in climb milling on both, the direction must be reversed.

Related offers

Project Race car (mechanical)Workshop Design & RaceNullpunkt: workshop in the browser

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.