Explanation
A stylus instrument moves a fine diamond tip across the surface and records the profile. The parameters are calculated from it. Ra averages all deviations and therefore barely reacts to single scratches or outliers. Rz captures the peak-to-valley heights and shows such individual defects more clearly. Rz is always greater than Ra; there is no fixed conversion between the two because it depends on the shape of the profile.
On the drawing the roughness appears on the surface texture symbol, often as a general specification for the whole part and individually for functional surfaces. The parameters were long defined in ISO 4287; since 2021 the ISO 21920 series governs profile roughness. Older drawings remain valid.
In turning the achievable roughness can be estimated from feed and corner radius. The theoretical roughness grows with the square of the feed: half the feed gives a quarter of the roughness. In practice vibration, wear and built-up edges add to it, so the value is a lower bound.
Formulas and worked example
Theoretical roughness in turning
feed per revolution, corner radius of the insert.
Given:
In practice: Race car (mechanical), Front axle
The race car's front axle has Ra 3.2 as the general value and Ra 0.8 on the ⌀6f8 bearing journal. The project data show how to meet this requirement without grinding and calculate it with the theoretical roughness formula. The buggy's rear body, by contrast, carries only Ra 12.5, the coarsest value in the project. That is correct, because a sheet metal part has no machined functional surface.
To the training project Race car (mechanical)
Common mistakes
- Treating Ra and Rz as equal or converting with a fixed factor.
- Requiring fine roughness everywhere. Each finer step costs time and often an extra operation.
- Measuring along and across the lay and comparing the results. Measurement is made across the lay.