Explanation
Not every dimension needs its own tolerance. For most dimensions normal workshop accuracy is enough. The general tolerance specifies how far they may deviate. The permitted deviation grows with the nominal size: a long dimension may deviate more than a short one. The finer the class, the tighter the limits and the more effort manufacturing takes. The values themselves are in the standard.
ISO 2768-1 applies to linear and angular dimensions on machined parts and formed sheet metal parts. It does not apply to auxiliary dimensions in brackets or to theoretically exact dimensions in a frame. Functional dimensions such as fits are toleranced individually.
Many drawings carry a note like ISO 2768-mK. The second letter referred to part 2 of the standard (classes H, K, L for general geometrical tolerances). That part was withdrawn in 2021 and replaced by ISO 22081; in Germany DIN 2769 adds values to it. Existing drawings remain readable; for new drawings it is worth checking the current standards.
In practice: Buggy, Engine block
All buggy drawings carry DIN ISO 2768-m-K. On the engine block the project data cover individual and general tolerances side by side: where a dimension is critical to function it has its own tolerance; all other dimensions fall under class m. On the rear body the general tolerance determines the acceptance range for the 170.52 mm developed length in the inspection report. The race car takes another route: its title block cites DIN EN ISO 14405 and dimensions are toleranced individually.
Common mistakes
- Assuming a dimension without a tolerance can be as accurate or as coarse as you like. The class in the title block applies.
- Specifying class f where m is enough. Manufacturing becomes more expensive without the part working any better.
- Leaving fit dimensions to the general tolerance. Functional dimensions need their own tolerance.