Skip to content
Stern Didactic GmbH

Knowledge · Materials

Steel designation

In Europe steels are designated by a steel name or a material number. The name says either something about the application and minimum yield strength (e.g. S235JR) or about the chemical composition (e.g. C45 or X5CrNi18-10).

Explanation

Names based on application start with a letter: S for structural steel, E for engineering steel, P for pressure vessels. The number that follows is the minimum yield strength in N/mm² for the smallest product thickness. S235JR is therefore a structural steel with a yield strength of at least 235 N/mm². Additional symbols describe further properties: JR stands for a specified impact energy of 27 J at room temperature (+20 °C), J0 and J2 for the same energy at 0 °C and −20 °C.

Names based on composition follow three patterns. Unalloyed steels: C and one hundred times the carbon content, so C45 has about 0.45 % carbon. Low-alloy steels: carbon index, alloying elements and their contents with multipliers, e.g. 42CrMo4 with 0.42 % carbon and chromium (index 4 divided by the factor 4, i.e. about 1 %). High-alloy steels: X, carbon index and the alloy contents in percent, e.g. X5CrNi18-10 with 0.05 % carbon, 18 % chromium and 10 % nickel.

The material number is a five-digit number such as 1.0038 (S235JR) or 1.4301 (X5CrNi18-10). The first digit 1 stands for steel, the next two for the steel group. It is shorter and unambiguous but says less about the material without looking it up.

In practice: Race car (mechanical), Suspension axle (pivot pin)

On the mechanical race car all three designation types appear side by side: pivot pin, front axle and steering knuckles are stainless steel, given in the drawing data as AISI 304, X5CrNi18-10 and 1.4301. The rear axle is steel; the suspension arm and steering rod are brass. On the buggy, by contrast, the material is given only as "steel"; the drawing does not specify the exact grade.

To the training project Race car (mechanical)

Common mistakes

  • Reading the number in S235 as tensile strength. It is the minimum yield strength.
  • Forgetting the multiplier for low-alloy steels and thinking 42CrMo4 contains 4 % chromium.
  • Regarding the US designation AISI 304 and the European material number as different materials. They largely denote the same grade; details are in the respective standards.

Related offers

Project Race car (mechanical)Project BuggyWorkshop Design & Race

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.