Skip to content
Stern Didactic GmbH

Knowledge · Materials

Hardening and tempering

Hardening is a heat treatment in which steel is heated and cooled so quickly that a very hard but brittle microstructure (martensite) forms. In the subsequent tempering the steel is reheated moderately to reduce brittleness and stresses.

Explanation

In hardening, the steel is brought to austenitising temperature, at which carbon dissolves in the iron lattice. If it is then quenched quickly, in water, oil or air depending on the grade, the carbon has no time to precipitate again. Martensite forms. How hard the steel becomes depends mainly on its carbon content; steels with very little carbon can hardly be hardened this way. Alloying elements such as chromium and molybdenum allow milder cooling and a greater hardening depth.

Hardened steel is too brittle for most applications. In tempering it is therefore heated to a temperature below the transformation temperature and held there. The higher the tempering temperature, the more hardness is lost and the tougher the steel becomes. Tools are tempered at low temperatures, parts that must absorb impacts at higher ones. Hardening followed by tempering at a higher temperature is called quenching and tempering. The right temperatures and times are in the steel's data sheet.

Not every steel can be hardened this way. Austenitic stainless steels such as 1.4301 do not form martensite on quenching. They do, however, become stronger through cold working, including unintentionally during machining.

In practice: Race car (mechanical), Left and right wheel carriers (steering knuckles)

The race car's steering knuckles are made of 1.4301. The project data use them to explain work hardening: if the edge cuts with too small a chip thickness, the surface layer hardens well above the base material, the next edge goes blunt and the cycle ends with tool breakage. The remedies are sufficient feed, sharp tools and climb milling. On the buggy's rear body the data note that bending changes hardness only locally in the bend zone.

To the training project Race car (mechanical)

Common mistakes

  • Trying to harden a low-carbon unalloyed steel. It hardly gets harder.
  • Not tempering after hardening. The part can crack or break in service.
  • Choosing the wrong quenching medium. Too severe quenching causes hardening cracks and distortion; too mild gives low hardness.
  • Finishing fit dimensions before hardening. Distortion and scale change the dimensions; functional surfaces are ground afterwards.

Related offers

Project Race car (mechanical)Project BuggyWorkshop Design & Race

Sources

Standards are named only; this page does not reproduce their content. As of 18 November 2026.